If you sew the pants and change the length of the pants smaller. Sometimes it is not easy to find a pair of pants. Even if you buy your own pants, you don’t fit. Modify your pants hand -made not only the clothes that are suitable for your figure, but also make them simple and money.
Measure the body size so that how many fabrics need to be cut off.
Flat the pants and draw it with a pencil along the pants. Measure the size of the pants and pattern to ensure the size of the size. Then, the size of the previously measured parts can be completed in proportion.
Set up a new fold edge. Fold the pants with straight needles. A new hem is sewed under the original hem of the hem (the fabric must be folded up and close to the top of the folding). The stitching on the legs must be straight and neat. After sewing, turn the needle or cut it and cut off the excess line.
Fold the sewing part. The bottom of the trouser legs sews a circle, folded the sewing fabric back to the legs of the trousers, and turned out the front of the trouser legs. you succeeded!
Remove the original hem and measure the size. Hold and remove the lower hem along the legs of 2 side trousers. Pull out all the lines, open the hem, and expose excess fabrics. Then measure the width of the hem with a tape.
Cut a few pieces as a lining to facilitate sewing new fold edges. If you want to change the length of the pants, you basically need to be lined on the edge of the unsfolled fabric, and then sew it with a small fold to lengthen the pants. Choose a neutral color fabric that matches the color of the pants (don’t worry, you can’t see it outside the pants). The fabric is measured according to the width of the trouser legs, and the width of 2.5cm is sewed, and the total width is 4 cm to 5 cm.
Stack the two pieces of cloth together and sew both ends (about 1.25cm) into a circle. Repeat the above steps to the other two cloths. After the completion, these two ring should be suitable for the bottom of the trouser legs. Ensure that the fabric is facing the front (the seams facing). Set the lunter into the hem, turn the pants, and put one of the lining on the edge of the bottom of the hem (ensure that the lining is still facing the outside). Align the edges of the two fabrics, and use straight needles to seam along the lower lower seam (about 7 mm from the bottom edge). The seams of the hem fabric are uneven or skewed, and they can be remedied in the future.
Take off the pants from the sewing machine and open the lintest that just sewed to the hem, the extra fabric will be exposed from the tail of the hem. Tiring with an iron, then folding the exposed cloth, folding the end of the cloth towards the middle of the lunatic, and then ironing the crease with an iron. After the completion, there will be a piece of about 2.5 cm wide cloth (library) at the bottom of the trouser legs.
Adjust the cloth to prepare the seam. Fold the exposed lining to the bottom edge of the hem to ensure that a small part of the lining and the bottom of the hem is exposed. Then turn out the front of the pants and just fold the fabric, so you should not see the lining at this time, but if necessary, you can fold more fabrics to completely cover the lining.
A new hem is sewed along the side. The distance between the hem and the hem is about 1.25 cm, but you can adjust according to the shape of the pants. Along the hem, to ensure that the lining of the hem is flat. After sewing on both sides of the trouser legs, it was completed.
Mix vinegar and water at a ratio of 3: 1, and iron it with this solution. It can remove the wrinkles or clicks left by the original hem, making the new hem looks like the only hem of pants. If you have no vinegar, you can iron the hem with a large amount of steam.
How to modify the pants when the pants are big? How to deal with the size of the pants?